E36 Z3M S54 CAN Bus Cluster Build Options:Comprehensive MSP Build Fuel Level Needle

Fuel Level Needle

All hardware is original specification but in higher quality metal

This spacer is a necessary part used to offset the charger position within the engine bay

New old stock (I only have one and this part has been NLA for awhile)

Modeled after the original ISR pulley

E36 Z3M S54 CAN Bus Cluster Build Options:Comprehensive MSP Build Fuel Level NeedleCustom built CAN Bus Z3M replica cluster for your S54 swapped E36 Comprehensive Built Clusters This is a fully built cluster with all parts supplied and programmed for your use. Customer Supplied Clusters An E36 M3 cluster (used only for the red needles if applicable) and a Z3 CAN 01 or CAN 02 or CAN 03 cluster is required for this selection. You will mail these in for assembly. IF THE Z3 CLUSTER BEING SUBMITTED DOES NOT STATE CAN 01 02 03 ON THE TOP